+1 (702) 963 3706
New in box FN P90/PS90 5.7x28MM full auto Machine Gun with no reserve. This comes with one 50 round mag plus free red dot sight and optic rail. This also has a 1/2×28 thread adaptor already installed so you can add a silencer or any other muzzle device.p90 for sale. We are giving a 1 year warranty with this also. These are manufactured in house to FN full auto spec! This is guaranteed to run 100% reliable! ITEM INFO CATEGORY: Machine Guns TYPE: Machine guns BRAND: FN MODEL: FN P90 CALIBER: 5.7x28MM TECH SPECS CAPACITY: 50 WEIGHT: 50 MATERIAL: Black SIGHT: Fixed PURPOSE: MACHINE GUNS
Brand new in box CZ Bren A2 post sample machine gun in 5.56mm. This is a 4 position 0-1-2-full. This is just like a FN Scar 16-17 but has 4 position! This comes one mag. This comes with a 30 day warranty
The Catco Sterling 9mm SMG submachine gun is constructed entirely of steel and plastic and has a shoulder stock, which folds underneath the weapon. There is an adjustable rear sight, which can be flipped between 100 and 200-yard settings. Although of conventional blowback design firing from an open bolt, there are some unusual features: for example, the bolt has helical grooves cut into the surface to remove dirt and fouling from the inside of the receiver to increase reliability. There are two concentric recoil springs that cycle the bolt, as opposed to the single spring arrangement used by many other SMG designs. This double-spring arrangement significantly reduces “bolt-bounce” when cartridges are chambered, resulting in better obturation, smoother recoil, and increased accuracy. Additionally, the Sterling uses a much-improved (over the Sten) 34-round curved double-column feed box magazine, which is inserted into the left side of the receiver. The magazine follower, which pushes the cartridges into the feed port, is equipped with rollers to reduce friction. The bolt feeds ammunition alternately from the top and bottom of the magazine lips, and its fixed firing pin is designed so that it does not line up with the primer in the cartridge until the cartridge has entered the chamber. The Sterling employs a degree of what is known as Advanced Primer Ignition, in that the cartridge is fired while the bolt is still moving forward, a fraction of a second before the round is fully chambered. The firing of the round thus not only sends the bullet flying down the barrel but simultaneously resists the forward’s movement of the bolt. By this means it is possible to employ a lighter bolt than if the cartridge was fired after the bolt had already stopped, as in simple blowback, since the energy of the expanding gases would then only have to overcome the bolt’s static inertia (plus spring resistance) to push it back again and cycle the weapon; whereas in this arrangement some of this energy is used up in counteracting the bolt’s forwards momentum as well, and thus the bolt does not have to be so massive. The lighter bolt makes not only for a lighter gun, but a more controllable one since there is less mass moving to and fro within it as it fires. The suppressed version of the Sterling (L34A1/Mk.5) was developed for covert operations. This version uses a ported barrel surrounded by a cylinder with expansion chambers. The Australian and New Zealand SAS regiments used the suppressed version of the Sterling during the Vietnam War. It is notable for having been used by both Argentinian and British Special Forces during the Falklands War. A Sterling was used by Libyan agents to kill WPC Yvonne Fletcher outside the Libyan Embassy in London, which sparked the 1984 siege of the building. The Sterling has a reputation for excellent reliability under adverse conditions and, even though it fires from an open bolt, has good accuracy. With some practice, it is very accurate when fired in short bursts. While it has been reported that the weapon poses no problems for left-handed users to operate, it is not recommended without the wearing of ballistic eye protection. The path of the ejected cartridge cases is slightly down and backward, so mild burns can occasionally be incurred by left-handed shooters. A bayonet of a similar design as that for the L1A1 Self-Loading Rifle was produced and issued in British Army service but was rarely employed except for ceremonial duties. Both bayonets were derived from the version issued with the Rifle No. 5 Mk I “Jungle Carbine”, the main difference being a smaller ring on the SLR bayonet to fit the rifle’s muzzle. When mounted, the Sterling bayonet was offset to the left of the weapon’s vertical line, which gave a more natural balance when used for bayonet-fighting. For a right-handed shooter, the correct position for the left hand while firing is on the ventilated barrel-casing, but not on the magazine, as the pressure from holding the magazine can increase the risk of stoppages, and a loose magazine can lead to dropping the weapon. The barrel-casing hold provides greater control of the weapon, so the right hand can intermittently be used for other tasks. A semi-circular protrusion on the right-hand side of the weapon, approximately two inches from the muzzle, serves to prevent the supporting hand from moving too far forward and over the muzzle.
Pre-May Sales Sample in Excellent Condition in the box with a factory original manual and magazine. F25510 Please note: This is a restricted Pre-May Sales Sample only available to FFL & SOT Dealers. In stock in our vault and ready for eForm transfer.
Hk MP5-40 sear host built by Jayson of Investment Grade Firearms. This was built using a brand new demilled German Hk MP5-40,mp5 for sale and a Special Weapons receiver. The original gun was new, it was a crime to have to cut the original receiver up, but the kit of genuine German parts was a real catch. The SW receiver was the final perfected model. I have built several of these guns with Jayson, and they have been in perfect compliance. As this gun was built from a brand new gun, it was my favorite. This gun was tested by Jayson in full-auto before it was finished; it ran perfect and it is in perfect condition.
The Bushmaster XM15E2 – M-16 – 5.56x45mm – 16 is in perfect working condition
Zenith Z-5RS post dealer sample machine gun in 9mm. The Zenith/MKE is an HK LICENSED VARIANT of the famous HK 9MM machinegun and is a double push pin. This gun can take any and all Genuine H&K factory parts. Parts are 100% interchangeable without modification.Parts like mags stocks internals Etc. We have a Full auto converted unit in our shop and have put over 1500 rounds through it without a single jam or malfunction, 100% reliability is what you can expect............ MKE supplies 29 countries with Everything from Ammunition and Small Arms to Tanks. These guns are top Quality Firearms from the MKE Turkish Military Plant. This comes with a threaded 1/2x28 tri-lug barrel and full auto SEF Pack. 3-30 round mags and your choice of the following stocks A3 F stock, side folding or A2. Also comes with cleaning kit, Scope mount rail and sling. So if you always wanted an MP5 sub gun this is the one for you. This is made on Licensed H&K factory machinery to H&K Specs. The finish is exact H&K factory spec. HENSE IT IS AS CLOSE AS H&K AS YOU CAN GET!!!!!!!! We guarantee this to be free from defects for 5 years. Buy with confidence
NFA Class 3 Ruger AC-556 machine gun in .223 and with 18.5†barrel. The action and bore are very good and this one works perfectly. Just test fired with two magazines and ran flawlessly with both steel and brass. Serial is 191-04059. Includes one 30rd magazine.
This Chester County Armory listing is for an extremely rare, fully select fire version of a Heckler & Koch MR223A3 5.56mm NATO transferable machine gun. This model started it's life being imported into the United States as a rare 14.5" HK semi-automatic pistol. The RAL8000 finish was done by Heckler and Koch, themselves, and is not an aftermarket finish. A transferable SWD Lightning Link was then installed by famed Lightning Link specialist John Ciszek of JEC Enterprises. John is known throughout the industry as "The Lightning Link Guy" because of extraordinary work making these custom setups run absolutely flawlessly! His work on this gun is no exception, as it is now a fully select fire setup that runs just like it came from the HK factory that way! This incredible specimen also features the factory correct HK factory front and rear back up iron sights. It also features the correct RAL8000 matching HK furniture and comes with a current generation HK Gen 3 30rd magazine, also in the RAL8000 finish. The host pistol is being offered as new condition, having only been fired by JEC Enterprises during the installation and testing of the SWD Lightning Link. It does note some minor handling-type marks on the exposed section of the barrel in the parkerizaton (see photos) however this was the condition in which it was originally imported. This weapon setup is only being offered for sale complete, and will not be separated by us. This NFA registered SWD Lightning Link is fully transferable, currently on a Form 3. The HK MR223 acting as a host gun will transfer as a standard Title One pistol.
We take pride in the quality and originality of our products
Our products reach our clients in a timely and discreet manner
We provide support for all customers at all times
If there are any defects upon arrival, do return the weapon and be refunded in full.